A screen protector protects the screen from scratches, dust, and resin damage, ultimately helping to maintain the printer's condition and resale value. It also makes maintenance easier by allowing for simple cleaning and avoiding the risk of damaging the screen.
Screen Protector (A3)
Materials Needed:
- Screen protector
- Cleaning cloth (lint-free)
- Alcohol wipe
- Dust removal sticker (you can use sellotape )
- Bank Card or similar flat toolInstallation Steps:
1. *Preparation*:
- Ensure your printer is turned off and unplugged.
- Find a clean, dust-free environment to work in.2. *Clean the Screen*:
- Use an alcohol wipe to gently clean the LCD screen. This step is crucial to remove fingerprints, oils, and any dust particles.
- After wiping, use a lint-free cloth to ensure the screen is completely dry and clean.3. *Remove Dust*:
- use the dust remover or tape to try to pick up any remaining dust from the screen.4. *Align the Screen Protector*:
- Carefully remove the protective film marked "A" from the screen protector, taking care not to touch the adhesive side.
- Position the screen protector over the LCD screen without pressing it down to check its alignment.5. *Apply the Screen Protector*:
- Once aligned, carefully lower the screen protector onto the screen. Start from one edge and slowly roll it out to avoid trapping air bubbles.
- If bubbles do form, you can gently lift the protector and push the bubbles towards the edge using a credit card or similar flat tool.6. *Final Touch-Up*:
- After the protector is in place, use the cleaning cloth to gently wipe the surface, removing any smudges or fingerprints.7. *Check the Installation*:
- Power on your printer and do an lcd test to just make sure it's working fineAdditional Tip:
- Do not rush the process; take your time to ensure a perfect installation.